Monday, December 10, 2018

Fitting a 15mm High Drive into a Gigabyte BRIX GB-BXBT-1900

You can just about squeeze a 15mm high hard drive into a Gigabyte BRIX BXBT case. I did it with the GB-BXBT-1900, but all the BXBT cases look to be the same.

The first thing I did was break off the U bend/clips at the end of the hard drive caddy.
Caddy
And fit the drive.
IMAG0168
Since every picometre counts screw the drive on to the bottom of the mount, not the side.
IMAG0169
The highest component in the case is the pair of USB sockets, but if you turn the base plate through 180° the drive will miss this and hit the slightly lower ethernet port.
IMAG0171
You still need an extra couple of mm and I found that nuts from a meccano set were perfect.
DSCF4203
Carefully place your spacers over the screw holes, put the base plate back in place and screw the screws back in.
IMAG0166
As you'd expect the case doesn't quite go back together perfectly but it seems stable enough.
IMAG0176
I checked the distance by dabbing a bit of paint on the top of the ethernet port. It's extremely close but not touching. I've had it running for a few days now without issue.

1 comment:

George Styles said...

Don't be tempted to update the firmware on that thing. I got one to use as a Dropbox and g drive linked file server, but the firmware update killed it and it had to go back.